Installation And Maintenance Of Intelligent Fire Emergency Light?

Intelligent fire emergency light is a commonly used lighting tool in fire emergency. It has the characteristics of low power consumption, high brightness and long service life. It has a power switch and a finger light on the side. It is applicable to prevent power failure in public places such as factories, hotels, schools and public places.

1. In the engineering design, in order to facilitate the daily maintenance and management, it is recommended that each floor of the intelligent fire emergency light be powered by a dedicated feeder circuit.

2. In order to ensure the reliability of power supply for intelligent fire emergency lights, the low-voltage emergency bus section of the substation shall be used as far as possible, that is, the diesel generator set shall be used as the emergency power supply. As long as the generator is put into use, there will be power to continue to ensure power supply.

3. In case of fire, there is less smoke and more oxygen near the ground. People's instinctive reaction to evacuation is to bend down or climb forward. Therefore, the local high illuminance lighting is more effective than the uniform illuminance brought by the high position installation. Therefore, low-level installation should be advocated, that is, evacuation emergency lighting should be set close to or on the ground.

4. The intelligent fire emergency lamp has been discharged when leaving the factory. It must be charged for 20 hours before discharging.

5. The performance of the intelligent fire emergency lamp in use shall be checked regularly, and the circuit conversion and battery emergency function shall be checked through continuous switch test every half a month or one month, and the battery life shall be extended by discharging.